IGF-1 LR3 — Certificate of Analysis
IGF-1 LR3
Lot IG1-2026-001 of IGF-1 LR3 assayed at 99.73% peptide purity by RP-HPLC against a ≥95.0% release specification, 4.73 percentage points clear of it. Released 07/17/2026 by ILS Laboratories, ISO/IEC 17025 Accredited. 83-residue Long R3 IGF-1 analog with an N-terminal extension and Arg3 substitution, used as a reference standard in growth-factor signaling research.
Net peptide content measured 1.05 mg against a 1 mg label — the mass of actual peptide in the vial, as distinct from salts, water and counter-ions. It is reported rather than graded, so it carries no pass/fail.
Full QC panel
| Analyte | Specification | Result | Status |
|---|---|---|---|
| Peptide Purity (HPLC) | ≥ 95.0% | 99.73% | Pass |
| Identity (HPLC-RTM) | IGF-1 LR3 Confirmed | Confirmed | Pass |
| Net Peptide Content | Report Only | 1.05 mg | — |
| Fentanyl Screen | Immunoassay, 50 ng/mL cutoff | Not Detected | Pass |
Sterility & endotoxin
| Test | Specification | Result | Status |
|---|---|---|---|
| Sterility (PCR) | No Growth | No Growth | Pass |
| Endotoxin (USP <85>) | Report Result | NMT 0.05 EU/mL | Reported |
Endotoxin is reported as a measured value rather than graded pass/fail: acceptable limits depend on route and matrix, and no universal threshold applies to research-use material. The laboratory reports the figure and leaves the judgement to you.
Elemental impurities
| Panel | Method | Result | Status |
|---|---|---|---|
| Arsenic, cadmium, chromium, lead, mercury | ICP-MS, USP <233> | 5 of 5 under limit | Pass |
Per-element measurements are on the signed certificate below and in the laboratory's own record.
Reference data
| Property | Value | ||
|---|---|---|---|
| Compound | IGF-1 LR3 | ||
| Also known as | Long R3 IGF-1, LR3 IGF-1, Long R3 Insulin-like Growth Factor-1 | ||
| Sequence | 83-aa analog (Arg3 substitution; N-terminal 13-residue extension) | ||
| Molecular formula | C400H625N111O115S9 | ||
| Molecular weight | 9117.6 g/mol | ||
| CAS number | 946870-92-4 | ||
| Physical form | Lyophilized powder | ||
| Storage | Store lyophilized powder at -20C protected from light and moisture; for extended storage -80C is recommended. Aliquot reconstituted solutions and keep frozen to minimize freeze-thaw cycles. | ||
Check this certificate with the laboratory, not with us. Open the laboratory's own record of lot IG1-2026-001 — a page we neither host nor control. Holding a vial already? Look up its lot number. For research use only.
The signed certificate
More certificates: Tesamorelin · Retatrutide (LY3437943) · BPC-157 · Tirzepatide · all published lots
